Instructions for mounting, touring, and heel attachment use.

Bulldog bindings use standard 4 hole mounting pattern.

You can use the brake plate as the template to mark the mounting holes on the ski.
The diamond shape hole in the middle of the plate is the pin line.

If you are using the binding for touring, place the brake lock under the brake plate.

Place the binding over the brake plate and screw to the ski.

Snap ski boot into the binding and make a mark on the ski at the heel of the boot.

Mount the heel riser 1/2 inch forward from the rear of the ski boot as shown below.

Use shorter mounting screws (11mm) for the heel riser.

Mount the heel riser with the prongs pointing towards the toe of the binding.

At this point, the binding should look like this.

Snap heel tube into the toe by squeezing the wires together and sliding the hooks for the wire into the holes in the rear of the wings.
The holes further to the rear of the binding are more 'active' (telebulldog has 5 holes, lite dogz has 3).

Loosen and tighten bottom bracket screw with 3 mm hex key.

Slide heel throw along tube until boot hits knobs as shown below and tighten bracket screw.

Heel attachment hooks under rear of heel riser when the binding is open.

...and unhooks when wings of the binding are down and locked.

Ski brake lock slides back and locks ski brake in a fixed position for touring.

Flip the heel riser up when touring. This makes touring easier and prevents stress on the front of the binding.

The bulldog bindings are 75mm norm and asymmetrical, there is a right and left binding.
Be sure to step into the correct binding…

Bulldog bindings mounted and ready to go…

Enjoy!